(08-28-2018, 12:27 PM)uunix Wrote: sgi-enth.. do you by any chance have the ability to insert a drive into the machine itself (internal drive slot) and if so, with the arrays disconnected create a stone from that?
If you can and it works, then I'd do a reboot with arrays attached, start up sw_config as you do, clearAll-create the existing, set the off-sets to zero and try selecting your array drives again with add-create..
These things are pain in the butts, I recall having this issue with a SUN StorEdge and I had to do all sorts of strange things. I sometimes believe that whatever holds the stoneFS information, sometimes does not get cleared down.
Just something worth trying.
Hi uunix,
I added a 300Gb SCSI back into the Tezro second slot, booted up with the FC trays off and ran sw_config. I successfully added the drive and saved the partition zero.
I then shut down, powered on the FC trays (leaving the 300Gb internal in place) and booted up the system.
I followed your suggestions and irrespective of the way I configured the drives (parity, spare, green) I still get the same error message when trying to save.
No luck.
Any other ideas I can try?
