(08-28-2018, 10:50 AM)Irinikus Wrote: I solved this problem by reinstalling Flame and following the following instructions: (When you uninstall Flame, make sure that you uninstall the autodesk programs such as backburner as well, as you will have trouble with the new Flame install if you don't. )
Make sure that your machine has a static IP address (this may effect your machine's internet connectivity) and don't make use of "root" at all when you deal with Flame. (Besides for installing Flame of course.)
Then login to flame account and in xwsh shell window:
su
cd /usr/discreet/sw
./sw_stop
./sw_config
then add/create drive
save and quit
./sw_start
./sw_mount all
partition should be mounted, if not (you check it with ./sw_df):
Hi Irinikus,
Thanks for the response. I just tried it again 2 minutes ago and I can't get past step 6 "save quit" it generates the same error message each time being,
"saving device information failed. loctl SWR SET CONFIG failed for partition 0 (/dev/swr00) Disk 4 (adapter 4, target 17) appears twice in the data disk list for partition id 0"
Doesn't matter which disk you make the parity or spare or even none at all, it still generates the same error message.
I have to get past this step because I can't use the other TP4600 array because the drives are only SATA 7200 RPM and they can't sustain the throughput for HD. If you try you just get "too many frame errors" messages in smoke/flame and recording stops.
stuck!
