[Geoman]

I have upgraded from Flame 9.5.14 to 2008 SP6. Runs fine so far, but sw_config won't work at all. "Segmentation fault". I had to create a framestore with the old Flame to work with 2008 SP6. sw_config.log does not help, even wirh swr_set_debug 2. No error is logged in this file. I'm rather clueless. I read all the important documentation and did a clean 6.5.28 installation strictly according to the Autodesk guide.
Could it be that it happens because I created a swap partition of 8192 megabytes instead of 256 mb, that the installation guide recommended?