[weblacky]

Code:

Advisory  Critical  Fault      Current
Description    State      Temp      Temp      Temp      Temp
-------------- ----------  ---------  ---------  ---------  ---------
NODE 0            Enabled  60C/140F  65C/149F  70C/158F  37C/ 98F
NODE 1            Enabled  60C/140F  65C/149F  70C/158F  32C/ 89F
NODE 2            Enabled  60C/140F  65C/149F  70C/158F  26C/ 78F
PIMM              Enabled  60C/140F  65C/149F  70C/158F    0C/ 32F
ODYSSEY          Enabled  60C/140F  65C/149F  70C/158F  28C/ 82F
BEDROCK          Enabled  60C/140F  65C/149F  70C/158F  38C/100F

Ugh env monitoring on PIMM is now dead. Will likely just replace it instead of trying to get a new chip. Just wish my o2 was this snappy, otherwise, I wouldn't have a need for these temperamental things.

I can fix that! Replacing the ENV monitoring chip on the Fuel PIMM is very easy. If your processor is working otherwise I’d be happy to replace it for a nominal fee. PM me if you’re interested. Otherwise you can change the chip out yourself if you’re handy with SMD soldering. The bigger issue is removing it from the board without using hot air. I don’t use hot air in any of the work I do. I use an extractor tip that matches that SMD size.

Does ENV still show good voltages for your PIMM values? Or are all ENV values erroneous or zero for all the PIMM readings in ENV?

PIMM VRM parts can go, which will provide the wrong voltage to parts of the CPU and can kill the environment monitoring chip. However, if your CPU is working normally and you’re not experiencing any cache errors during PROM testing or operating system freezes, then environmental monitoring chip simply went bad and a replacement may get you back going. I can quickly check parts of the VRM for you, but it won’t be an exhaustive test unless I start desoldering things. Which I don’t normally do.