[weblacky]

Once you get the L2 working, you hook up the individual systems via USB cable.
Pay attention to the serial of each system - it must be unique.
When I manage my Fuel over L2 - it's exactly the same as using the serial port inside
When I manage my dual O300 with numa link, I can use the "*" to issue commands to BOTH nodes at the same time (like "* power up") or prefix with the individual machine's ID to only talk to the one.
The benefit for me is not having to use the internal L1 serial port in my Fuel.

Yes, I finally convinced myself to just get one. It's just that the instructions talk about a numerator system is based on rack & slot number and such and I was curious if anyone knew how in the heck to navigate if you hook up more than one workstation system to it.

However it's highly likely that what I'll be doing is using it entirely in telnet mode on a single system at a time. But you never know.