[soviet]

Found this 3d model here: https://www.thingiverse.com/thing:246137
Very cool, because finding these stands in the wild is hard and expensive.

They are 2 models in there one (low profile stand) and the full size one, that is the one I like to print.
The full size is called on the thing files "sgi_foot.stl", so printed it, and the stand prints like they are 2 models one on top of the other.

The 2 halves are completely apart, first believed that it was a print error but after reprinting got the same issue.
Looking at the generated gcode I can see a gap in there, not very good at blender and can't figure out how to join the gap.

Not good at 3d modeling at all.

Here are a couple of pictures from the gcode "gap" and the results.