[weblacky]

Hi Weblacky,

the obvious one is the big on front side, near the serial part no label

The problem is that a bunch of the smaller surface mount tantalum capacitors have been knocked off the bottom of the board... (not really easily seen on photo, but on inspection you can see where some have been knocked off the board).

I will mark up what I can see and start new thread for that...

Also I did a bit of a web surf for 28 PIN Test Clip and found this: https://www.farnell.com/datasheets/193574.pdf

But at 32K Bytes that chip does not provide enough space for the ~ 1.5 M Bytes that was written / dumped...

So still not clear if this is the right chip.

Cheers from Oz,

jwhat/John.

 Hmm...It's not obvious to me as I cannot see anything near a serial port (side or L1) that doesn't have markings and is missing.  I do see a fair amount of scratch/strike damage on the back and can see where more than few small SMD components might be.


Please just take some time to carefully markup the pictures to show missing areas to make it easier for me to tell what's what.  Right now I cannot even locate the top one you're talking about.