[weblacky]

Hi Weblacky,

to:
"Can someone with a working Fuel please do a debug 0x010d and a error_dump and see what comes up. What's it supposed to say?:

Its not very exciting....
>> A 000 001c01:
>> A 000 001c01: *** Entering POD mode on node 0
>> A 000 001c01: POD SysCt Cac> error_dump
>> A 000 001c01: Hardware Error State: (Forced error dump)
>> A 000 001c01: END Hardware Error State (Forced error dump)
>> A 000 001c01: POD SysCt Cac>

Also I also only get diags via serial port on the system board (not via the external com1 port).

I have not done full test, but believe that this is likely right behaviour, as with keyboard/mouse plugged it it expects to send boot console output to graphics "textport".

Cheers from Oz,


jwhat/John

Hmmm…well I hope that’s right.  I’ll do more testing to see if I now magically have both L1 & console on the same serial!  I sure didn’t before!  Super irritating.  

darn, so that error isn’t like that TLB and vestigial.

Well, if tests prove sound I’ll start firmware march, using your download, perhaps that will cure what ails mean!  

I’d sure like to stay clean of errors and not have any loose ends at the end of this. 

Thanks for confirming that output!