[kokoboi]

I've just tried this.
enableall does not execute

>> enableall
Enable/Disable table not setup in NVRAM
>>

Even L1 complains about missing IO9

INFO: Cannot enable VRM: 9
INFO: Cannot enable VRM: 10
INFO: Cannot enable VRM: 11
ALERT: IO9 EEPROM read error, no acknowledge


SGI SN1 L1 Controller
Firmware Image A: Rev. 1.40.6, Built 01/06/2006 13:16:50

BASEIO PROM too:

BASEIO PROM Monitor SGI Version 6.210  built 02:30:38 PM Aug 26, 2004 (BE64)
4 CPUs on 1 nodes found.
****************************************************************
*      WARNING:  No BASEIO board found -- the system        *
*                  will not be able to boot.                  *
****************************************************************
WARNING: Did not find an IOC3 or IOC4 NVRAM base address
WARNING: Did not find an IOC3 or IOC4 UART base address

NVRAM checksum is incorrect: reinitializing.
Automatic update of PROM environment disabled

Probably the SCSI chip on IO9 has been fried. Any idea for a new SCSI adapters for the tezro available on eBay ?