[roach-commuter]

I purchased an HP Drive Cage that was used with Proliant servers (HP SCSI Drive Cage 2-bay Hot Plug Wide U2 with 258051-001 253761-001 351126-001) with the intention of pimping up my Fuel by basically installing it and using these drives instead of the standard drives. This cage has a 68 pin connector and is meant to be used with LVD U320 disks so I thought this would be perfect. The cage has 2 slots, one is marked as 0 and the other as 1. I believe these are also the scsi IDs that get assigned automatically to the drives when you slide them in. Now if I place 2 drives in it , I can see that the fuel does not like it. Hinv spits out some preposterous info and it tells me I have like 15 drives installed. The same goes if I only leave the drive in the 0 slot. However if I remove drive 0 and only leave drive 1 , hinv only sees 2 drives. A drive 1 and a drive 15 (Drive 1 is ok , but where does the drive 15 come from? I think it's an artifact caused by the drive cage rom or something. Since I don't have the drive cage manuals I am curious : is ti possible to change the default scsi ID for the Fuel controller (which I believe is set to 0) ?