[kokoboi]

I've replaced the snaphat battery on IO9
Initially I didn't get this message:

Starting PROM Boot process
io_config_space: Found 0 Qlogic devices BASEIO; expected 1 or more.
io_config_space failed:
RSLT io_config_spac FAIL                diag_rc = 53
diag_io6confSpace_sanity: /hw/module/001c01/xtalk/15: FAILED

However it still missess "Walking SCSI Adapter" step... After several power down/up the message re-appears.
I'll replace the dallas chip....  if this doesn't fix the problem it could be bad mainboard or bad IO9 adapter.

On the other hand the lan is on the same adapter and seems to be functional:

graphics install: searching for pipe 0
Probing IOC4 ATA adapter 2
IOC4 RevId = 83
Initializing PROM Device drivers ..........
  Initializing Base I/O Ethernet Interface...Done.
  ---------------Interface Configuration Summary----------------
  ASIC|Revision|MAC Address      : 5701|B5|08:00:69:11:dc:4b
  Link Negotiation|Advertisement  : On|<H10 F10 H100 F100 H1000 F1000>
  Link|Speed|Duplex|Rx/Tx FlowCtrl: Up|1000|Full|Off/Off
  --------------------------------------------------------------
DONE

Best regards,
Plamen