Hi,
I have some issues with my IR graphics. There is for sure at least one problem (there is no output signal). I ran irsaudit and got errors, but I'm not sure where the problem lies and what it is connected with.
First of all I ran the gfxinfo and irsaudit without any options and I got strange output from gfxinfo and error on irsaudit with DG. Then I ran irsaudit with -ge -rm and -dg options and each time I got error. During irsaudit -rm the was and error and Onyx was restarted. What do You think, are all these errors connected together and there is a single cause - e.g. DG board?
I attached all the results from irsaudit, gfxinfo and hinv.
Code:
/usr/gfx/gfxinfo
Graphics board 0 is "KONAS" graphics.
Unmanaged 104x38555
Display has 2623476 channels
88 GEs (of 803405443), occmask = 0x7ec
GEs BEF ram, 16bit path
205583996 RM7 boards (of 2024) 68/7ec/2ce29759/68
Texture Memory: ///
boards pixel depth
0K cmap
GPI interface device detected
Xvc info not available for unmanaged boards
Code:
hinv
2 196 MHZ IP25 Processors
CPU: MIPS R10000 Processor Chip Revision: 2.5
FPU: MIPS R10010 Floating Point Chip Revision: 2.5
Main memory size: 512 Mbytes, 2-way interleaved
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 1 Mbyte
Integral SCSI controller 0: Version WD33C95A, single ended, revision 0
Integral SCSI controller 1: Version WD33C95A, differential, revision 0
Disk drive: unit 1 on SCSI controller 1
Integral SCSI controller 90: Version WD33C95A, differential, revision 0
Integral SCSI controller 91: Version WD33C95A, differential, revision 0
Integral EPC serial ports: 8
Integral EPC parallel port: Ebus slot 11
Integral EPC parallel port: Ebus slot 9
Graphics board: InfiniteReality
Integral Ethernet controller: et0, Ebus slot 11
I/O board, Ebus slot 11: IO4 revision 1
I/O board, Ebus slot 9: IO4 revision 1
VME bus: adapter 45
VME bus: adapter 0 mapped to adapter 45
EPC external interrupts
