Hi,
I've just acquired an Origin 200 which I'm attempting to get going.
Unfortunately I don't know much about its background.
It came with 4 x 64MB DIMMS (013-1372-002).
Whenever I turn it on I get a memory test fail.
I've tried multiple combinations of the DIMMs in Bank 0 (Slots 1 & 2)
I've also tried multiple combinations of the DIMMS in Bank 1 (Slots 3 & 4)
Regardless of the combination, I get a memory test failure:
Code:
IP27 PROM SGI Version 6.150 built 11:59:56 AM Sep 29, 2003
using BaseIO nic
Testing/Initializing memory ...............
*** Memory data bits stuck at 1 (act: 0x000000000000007e, exp: 0x0000000000000000)
memtest failed: stuck at 1
RSLT memtest FAIL diag_rc = 43 stuck at 1
*** Memory data bits stuck at 0 (act: 0xfffffffffffffc7f, exp: 0xffffffffffffffff)
memtest failed: stuck at 0
RSLT memtest FAIL diag_rc = 43 stuck at 0
A: +----------------------------------+
A: | Memory problems found in bank 0 |
A: | on Node board in slot n1. |
A: +----------------------------------+
*** WARNING: Disabling memory bank 0 in module 1 slot 1
DONE
*** No useable RAM installed. Need working and enabled memory in bank 0 or 1
*** Add working and enabled memory present in bank 0 or 1 and reset the system
I've cleaned the slots contacts and DIMM contacts with isopropyl (although they were very clean to start), but still get the failures.
At this stage I'm assuming I either have multiple faulty DIMMS, or a faulty board.
Does anyone have any suggestions for bringing this machine to life?
What does it mean by "enabled memory"?
