[Geoman]

Does somebody own a "4-way BNC Breakout Cable for RAD Audio: 65 UKP (SGI PN 018-0648-001)" to check it via multimeter??
-- even Ian does not have it, and every distributor gives me a "not in stock" quote, because I would rather buy than solder but here we go again...

One would think compared to the "LVDS-cable hell", this would be easy, because of the good documentation. BUT there are a lof of grounds. Can I / do I have to connect these ground together? Like in the graphics below? The pinout is:

Code:

1, COAXIAL DIGITAL_IN GND
2, COAXIAL DIGITAL_IN
3, VID_REF
4, VID_REF GND
5, VID_REF
6, VID_REF GND
7, NOT CONNECTED
8, CHASSIS GND
9, COAXIAL DIGITAL_OUT
10, NOT CONNECTED
11, COAXIAL DIGITAL_OUT GND
12, NOT CONNECTED
13, CHASSIS GND
14, CHASSIS GND
15, NOT CONNECTED