Service / Repair Manual for SGI 1600SW - Printable Version

+- IRIX Network Forums (//forums.irixnet.org)
+-- Forum: SGI/MIPS (//forums.irixnet.org/forum-3.html)
+--- Forum: Hardware/Triage/Repair (//forums.irixnet.org/forum-11.html)
+--- Thread: Service / Repair Manual for SGI 1600SW (/thread-1657.html)

---

Service / Repair Manual for SGI 1600SW - Hulting74 - 11-28-2019

Hi

Anyone have the Service / Repair Manual for SGI 1600SW?

I got one for free but it will not "talk" to the SGI O2, the 1600 blinks yellow but the O2 does not recognise that its connected.

Any suggestions?

Regards,

Stefan

---

RE: Service / Repair Manual for SGI 1600SW - vishnu - 11-29-2019

This is how you take it apart, once you have it apart you're on your own as to how to fix it, good luck! Link:

https://s3-us-west-1.amazonaws.com/niktecimages/SGI+1600SW+CCFL+LAMP+REPLACE+NIKTEC.pdf

---

RE: Service / Repair Manual for SGI 1600SW - Jacques - 11-29-2019

Also have a look at the Niktec website, they still stock and sell parts for the 1600SW. At the bottom of some of the listed parts you'll find take-apart and replacement guides, quite useful. I wish I could buy a replacement lamp assembly but it would cost the earth to ship to the UK.

https://www.niktec.com/manufacturers/sgi.html.

[I think vishnu's link points to the same file listed on the website.]

---

RE: Service / Repair Manual for SGI 1600SW - Hulting74 - 11-29-2019

Hi

Thanks! Now for the fun problem with troubleshooting why the monitor it not detected by the SGI O2... :-)

/s

---

RE: Service / Repair Manual for SGI 1600SW - Jacques - 11-29-2019

Check the flat panel adapter is seated properly on the motherboard, mine clicks in with an audible 'click'.

---