[weblacky]

Okay, I'll admit it, I'm scared. I don't really know where to move from here. So I'd like to test if my voltage issue is resolved..but I really don't feel good reflashing my board for lower speed. My gut says...you're pushing your chances too hard! I was thinking about at LEAST placing the PIMM in (like I did before) and seeing if the voltage errors resolve. I think the cache issues I saw could have been due to the incorrect speed (programmed currently at a faster access speed).

If I just place it in and do a POD stop then that should give me a place to check the 5V and 12V PIMM voltages (which did instantly appear when I did this before). That should be very telling! But it won't really "test" the CPU definitively.

If I already had a 600Mhz system I'd have no issues just swapping. Maybe if my voltage test works there might be a Fuel 600Mhz owner who'd be willing to swap this PIMM into their system and see if it runs?

I'll probably do the voltage test as that at least will settle the voltage/shorted issue right away.