IRIXNetwork


  1. IRIX Network Forums
  2. SGI/MIPS
  3. Hardware/Triage/Repair

Most likely fault location on a GR1.5...
#11
RE: Most likely fault location on a GR1.5...
(09-19-2019, 09:03 AM)weblacky Wrote:  Preheat the board and you'll find the reflow will be much easier.
Not only that, if there's any moisture in the PCB it may turn to steam when you pass it through a reflow oven and tear up the PCB.


[Image: collection.png]
Keeping TechPubs alive!

 jan-jaap
SGI Collector

Trade Count: (0)
Posts: 1,048
Threads: 37
Joined: Jun 2018
Location: Netherlands
Website Find Reply
09-19-2019, 09:10 AM
« Next Oldest | Next Newest »


Messages In This Thread
Most likely fault location on a GR1.5... - by mapesdhs - 09-18-2019, 07:25 PM
RE: Most likely fault location on a GR1.5... - by ColanderCombo - 09-18-2019, 07:57 PM
RE: Most likely fault location on a GR1.5... - by jan-jaap - 09-18-2019, 09:02 PM
RE: Most likely fault location on a GR1.5... - by mapesdhs - 09-18-2019, 09:35 PM
RE: Most likely fault location on a GR1.5... - by ColanderCombo - 09-18-2019, 09:52 PM
RE: Most likely fault location on a GR1.5... - by jan-jaap - 09-19-2019, 10:23 AM
RE: Most likely fault location on a GR1.5... - by weblacky - 09-19-2019, 12:55 AM
RE: Most likely fault location on a GR1.5... - by jan-jaap - 09-19-2019, 05:40 AM
RE: Most likely fault location on a GR1.5... - by mapesdhs - 09-19-2019, 08:51 AM
RE: Most likely fault location on a GR1.5... - by weblacky - 09-19-2019, 09:03 AM
RE: Most likely fault location on a GR1.5... - by jan-jaap - 09-19-2019, 09:10 AM
RE: Most likely fault location on a GR1.5... - by mapesdhs - 09-19-2019, 09:09 AM
RE: Most likely fault location on a GR1.5... - by mapesdhs - 09-19-2019, 10:40 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)