[kaigan]

Hey, folks,

I'm sending out a request to any Tezro owners who would be able to take some pictures (ideally in high resolution) of the plastic top panels of their systems, along with some accurate measurements. My own Tezro is missing its panel, so I've decided to try to fabricate a new one. I can work my way around in Fusion3D half-decently, and I'd like to try to create and 3D print a prototype replacement. If it goes well, I'd eventually like to do the rest of the panels. If it goes really, really well, I'd then move on to other SGI systems.

Of course, the finalized files would be made available to the community and shared for modification and improvement. I'm no expert in this type of thing, but I should be able to rig up something serviceable with some time and effort. More experienced people could always take it from there.

What I'm looking for is as follows:

* Pictures of the top, bottom, and each side (from head-on) of the panel.
* Measurements of the overall length, width, and depth of the panel. For the depth, this includes at the center of the panel and at the top of each of the raised bumps.
* Measurements of any lips or insets on the panel from the maximum exterior plastic.
* Any appropriate measurements of supports where the top panel screws into the metal case.

The more data I can get, the better. Hurray for larger sample sizes.

Thank you in advance!