[callahan]

Just be aware that you can't output 1920x1080_60 through a 13W3, however you can output 1920x1200_60!

If your screen doesn't support 1920x1200 and you set it in setmon, you will have to go in via serial to reset the graphics settings, so be careful!

---

confirm you installed it properly? It's funny that it didn't call for libSDL when you did the install?

You're going to need to install "neko_libSDL-1.2.so.1.1" it's available in nekoware.

This video that I made, showing the installation of neko_xfe, should give you some idea or guidance as to how to go about installing nekoware: (It's a rather tedious process!)

https://youtu.be/GX4SilCS16A

I thought you could fix it via the command monitor, loading irix without gfx, and then using setmon. The machine will boot to 1024x768 (I think? Or 1280x1024 maybe) and only switches to the higher resolution when graphics start. I've never had to do this, so not sure what the exact command sequence is.