[Jacques]

Before my system disk threw a bearing and my V6 gave up (all in one day!), I managed to build a VFO file for SSI/SSE/MXI/MXE Octane boards for 1920x1200 @60Hz. However, whenever I ran the mode I experienced glitches (much like the O2 glitches when going close to the pixel clock range). I'm not sure if it's my SSE board throwing a wobbly or if the card is just being taxed too much.     

The build is based on 2RSS (so not SI/SE single raster boards) with single buffering only as there isn't enough framebuffer memory for double buffering. (it throws errors when trying to build for double buffering)

Furthermore, the build is also based on reduced blanking to try and stay <160Mhz pixel clock. I'm not sure whether it's the reduced blanking throwing the edge condition glitches.

So, is there anybody else out there with SSE/SSI/MXI/MXE boards who would be willing to test this? The VFS source file is based on EDID for a Dell 2407wfp panel. 

You'll need to copy the file to the location below for xsetmon to read it. 

Code:

/usr/gfx/ucode/MGRAS/vof/2RSS/

https://www.dropbox.com/s/0lndbq96uwmmz4...0.sdb?dl=0