[vladio]

I sent a Maya scene to render on my Onyx2 and noticed I only had 6 cpu's active, 8 are installed. I went back to the console and it appears I might have some bad memory that's disabling the cpu's. I wasn't able to copy/paste from the console so I typed this out, hopefully I didn't miss something.

Code:

DIAG RESULTS:
/hw/module/1/slot/n1/node/mem: MEMBANK(S) 6 disabled
reason: Bank 6: some DIMMs failed mem test.
/hw/module/1/slot/n2/node/cpu/0: CPU A disabled
Reason: PROM copied to memory (bank 0) is bad.
/hw/module/1/slot/n2/node/cpu/1: CPU B disabled
Reason: PROM copied to memory (bank 0) is bad.
/hw/module/1/slot/n2/node/mem: MEMBANK(S) 1 disabled
Reason: Bank 1: Some DIMMS failed mem test.

   
The system shows 15GB active, It's been a while, if I remember correctly there's 16GB installed. 

Should I pull node 1 and try reseating the memory? Any other suggestions?

When I check the node led's it appears that node 2 is the node that's inop.

[img][/img]