IRIXNetwork


  1. IRIX Network Forums
  2. SGI/MIPS
  3. Hardware/Triage/Repair

Challenge S Challenges
#6
RE: Challenge S Challenges
I just tested the unloaded power supply voltages, and they all look good. The yellow wire reads ~8V, but according to this post it should read 8V when not under load.

https://forums.sgi.sh/index.php?threads/...mation.14/
[Image: O2.png][Image: O2.png][Image: O2.png][Image: 1600SW.png] [Image: Octaneb.png] [Image: Indy.png]


 fleeno
O2

Trade Count: (0)
Posts: 12
Threads: 3
Joined: May 2018
Find Reply
08-28-2025, 11:25 PM
« Next Oldest | Next Newest »


Messages In This Thread
Challenge S Challenges - by fleeno - 08-28-2025, 02:48 AM
RE: Challenge S Challenges - by Raion - 08-28-2025, 04:17 AM
RE: Challenge S Challenges - by vishnu - 08-28-2025, 08:12 AM
RE: Challenge S Challenges - by robespierre - 08-31-2025, 05:00 AM
RE: Challenge S Challenges - by weblacky - 08-28-2025, 05:32 AM
RE: Challenge S Challenges - by fleeno - 08-28-2025, 08:19 PM
RE: Challenge S Challenges - by fleeno - 08-28-2025, 11:25 PM
RE: Challenge S Challenges - by vishnu - 08-29-2025, 02:37 PM
RE: Challenge S Challenges - by weblacky - 08-31-2025, 05:42 AM
RE: Challenge S Challenges - by fleeno - 09-02-2025, 12:27 AM
RE: Challenge S Challenges - by robespierre - 09-02-2025, 01:37 AM
RE: Challenge S Challenges - by fleeno - 09-02-2025, 01:39 AM
RE: Challenge S Challenges - by weblacky - 09-02-2025, 01:51 AM
RE: Challenge S Challenges - by fleeno - 09-02-2025, 02:08 AM
RE: Challenge S Challenges - by fleeno - 09-02-2025, 09:20 PM
RE: Challenge S Challenges - by fleeno - 09-03-2025, 06:41 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)