[mc68k]

Just trying to revive an old R3000 Indigo 1, entry level graphics.

MB battery ok, PSU caps replaced (4x 3300 uF), PSU voltages are ok.

Boot tune plays, serial console is alive, all tests pass, except the graphics board: it is not detected at all.

Error-- cannot open console "gfx(0)"

The graphics board is not listed in hinv at all. Keyboard is connected and detected. Printenv shows gfx=dead (but not "no keyboard").

Already purchased a replacement gfx board, the same issue with it. I can't believe both cards are defective.

Any hint?