IRIXNetwork


  1. IRIX Network Forums
  2. SGI/MIPS
  3. Hardware/Triage/Repair

Origin 300 is not starting
#1
Origin 300 is not starting
I've acquired an Origin 300 that, unfortunately, is not working. I can connect to L1 and the L1 responds to some commands ("env", "serial", "version", "cpu") but after "power up" command, I can hear the fans starting and then ... nothing. After a while on terminal screen the message 
"ERROR: no command response from 001c24, TIMEOUT" 
appears. After that the L1 doesn't responds to any command, I have to disconnect the power in order to turn the fans OFF.
Should the fact that it was brick #24 into a bigger system maters? Should I try to reset the brick to "1"?
Any thoughts?
Tank you all for great help.
Indigo2  Indigo2 R10000/IMPACT  Indigo2 R10000/IMPACT  Indigo2 R10000/IMPACT   O2  1600SW-on  Octane2  Octane2   Fuel  Tezro Indy    Origin 350
blacksmith
Tezro

Trade Count: (1)
Posts: 57
Threads: 17
Joined: Jun 2018
Find Reply
03-31-2022, 02:36 AM
« Next Oldest | Next Newest »


Messages In This Thread
Origin 300 is not starting - by blacksmith - 03-31-2022, 02:36 AM
RE: Origin 300 is not starting - by weblacky - 03-31-2022, 04:02 AM
RE: Origin 300 is not starting - by jwhat - 03-31-2022, 06:19 AM
RE: Origin 300 is not starting - by blacksmith - 04-01-2022, 02:07 PM
RE: Origin 300 is not starting - by Irinikus - 04-01-2022, 02:15 PM
RE: Origin 300 is not starting - by weblacky - 04-01-2022, 04:41 PM
RE: Origin 300 is not starting - by blacksmith - 04-04-2022, 02:44 AM
RE: Origin 300 is not starting - by jan-jaap - 04-04-2022, 08:58 AM
RE: Origin 300 is not starting - by blacksmith - 04-11-2022, 04:05 PM
RE: Origin 300 is not starting - by weblacky - 04-11-2022, 05:36 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)