[jwhat]

Hi Weblacky,

the HBA (IT) or RAID configuration is based on the firmware flashed onto card.

You should flash with the HBA firmware.

I think this is why you did not have to erase your prom first.

When changing from RAID to HBA firmware you need to erase prom first to allow change over.

Boot on PC and bring up bios configuration mgt and post picture of what it reports.

It should report as: 1.33.00.00-IT where IT == Initiator == HBA (not RAID).

The RAID and IT firmware image variants are identified by naming convention.

NOTE: I have experienced cases when SATA SSD is visible on PC but not on SGI, not sure of cause of this … but in general SATA SSD seem to work ok.

cheers from Oz,


jwhat/John.