[jwhat]

Hi Weblacky,

sorry, I recalled incorrectly.

On Fuel did regular boot and then stopped mediad and other non-essential daemons and then run the online diags.

It was with Octane diags that I had to run in single user mode.

I am pretty sure this is what I recorded up in thread, which I could not find earlier...

Here is my Fuel hinv:
>> hinv -mv
>> Location: /hw/module/001c01/node
>> IP34 Board: barcode MSM019 part 030-1707-003 rev -H
>> Location: /hw/module/001c01/node/cpubus/0
>> IP34PIMM Board: barcode NPJ858 part 030-1932-001 rev -B
>> Location: /hw/module/001c01/Ibrick/xtalk/13
>> ASTODY Board: barcode MNT914 part 030-1726-003 rev -E
>> Location: /hw/module/001c01/Ibrick/xtalk/14
>> IP34 Board: barcode MSM019 part 030-1707-003 rev -H
>> Location: /hw/module/001c01/Ibrick/xtalk/15
>> IP34 Board: barcode MSM019 part 030-1707-003 rev -H
>> 1 800 MHZ IP35 Processor
>> CPU: MIPS R16000 Processor Chip Revision: 2.2
>> FPU: MIPS R16010 Floating Point Chip Revision: 2.2
>> CPU 0 at Module 001c01/Slot 0/Slice A: 800 Mhz MIPS R16000 Processor Chip (enabled)
>> Processor revision: 2.2. Scache: Size 4 MB Speed 400 Mhz Tap 0xa
>> Main memory size: 4096 Mbytes
>> Instruction cache size: 32 Kbytes
>> Data cache size: 32 Kbytes

So I am running early revision of system board (based on SGI Depot parts list)

Also noticed that you and have:
- same CpuMask env setting, so this must not be related to speed,
- I have additional "Premium f" flat, which might relate to memory modeules as Fuel & O350 has concept of "Premium" (1024 MB) modules with faster speed

Also note, there are multiple version of the diags floating about... as per your other thread: https://forums.irixnet.org/thread-3205.html

Cheers from Oz,


jwhat/John