[jwhat]

Hi Weblacky,

to:
"Can someone with a working Fuel please do a debug 0x010d and a error_dump and see what comes up. What's it supposed to say?:

Its not very exciting....
>> A 000 001c01:
>> A 000 001c01: *** Entering POD mode on node 0
>> A 000 001c01: POD SysCt Cac> error_dump
>> A 000 001c01: Hardware Error State: (Forced error dump)
>> A 000 001c01: END Hardware Error State (Forced error dump)
>> A 000 001c01: POD SysCt Cac>

Also I also only get diags via serial port on the system board (not via the external com1 port).

I have not done full test, but believe that this is likely right behaviour, as with keyboard/mouse plugged it it expects to send boot console output to graphics "textport".

EDIT #1: If you do boot without keyboard/mouse and then go into command prompt and do printenv, then you will see different values for ConsoleIn/Console/Out than if you boot into graphics mode. On my Fuel it has /dev/tty/hubtty0 or something like that (verified), which I presume is the system board serial port as distinct from /dev/ttyd1 for instance, which is the external com1 port.

EDIT #2: If you do graphics boot then ConsoleIn=/dev/input/ioc3pckm0 (keyboard I expect) and ConsoleOut=/dev/graphics/textport , you can also login via L2 and going into Console mode (Ctl-D)

Cheers from Oz,


jwhat/John