Hi folks,
I need your lights as I'm having a tough time with my MENET board (on Octane).
To make it short:
- The board is probed (see hinv hereunder)
- Only 2 Ethernet ports (out of the 4) are discovered
- Only 2 Serial ports (out of the 6) are discovered
- Serial ports appear to work strangely: sometimes it works fine, then for some time nothing appears (no communication) and it comes back to normal again
Any idea how to move forward?
Here is the hinv:
Code:
PM10600MHZ Board: barcode MET805 part 030-1774-002 rev A
IP30 Board: barcode KVY924 part 030-1467-001 rev D
PWR.SPPLY.ER Board: barcode AAE1480138 part 060-0035-003 rev A
FP1 Board: barcode KSV972 part 030-0891-003 rev G
ODY128 Board: barcode LDJ915 part 030-1404-003 rev A
MENET Board: barcode GPS727 part 030-0873-003 rev G
1 600 MHZ IP30 Processor
CPU: MIPS R14000 Processor Chip Revision: 2.4
FPU: MIPS R14010 Floating Point Chip Revision: 0.0
Main memory size: 2048 Mbytes
Xbow ASIC: Revision 1.4
Instruction cache size: 32 Kbytes
Data cache size: 32 Kbytes
Secondary unified instruction/data cache size: 2 Mbytes
Integral SCSI controller 0: Version QL1040B (rev. 2), single ended
Disk drive: unit 1 on SCSI controller 0
Integral SCSI controller 1: Version QL1040B (rev. 2), single ended
IOC3/IOC4 serial port: tty1
IOC3/IOC4 serial port: tty2
IOC3/IOC4 serial port: tty3
IOC3/IOC4 serial port: tty4
IOC3 parallel port: plp1
Graphics board: V8
Integral Fast Ethernet: ef0, version 1, pci 2
Fast Ethernet: ef1, version 1, pci 2
Fast Ethernet: ef2, version 1, pci 3
Iris Audio Processor: version RAD revision 12.0, number 1
Hardware info:
Code:
/hw/node/xtalk/9/pci/0/# ls
/hw/node/xtalk/9/pci/1/# ls
/hw/node/xtalk/9/pci/2/# ls
.guest .master base config dma ef intr ioc3 mem mem.be mem.le rom rom.be rom.le usrpci
/hw/node/xtalk/9/pci/3/# ls
.guest .master base config dma ef intr ioc3 mem mem.be mem.le rom rom.be rom.le usrpci
/hw/node/xtalk/9/pci/4/# ls
.master usrpci
/hw/node/xtalk/9/pci/5/# ls
.master usrpci
/hw/node/xtalk/9/pci/6/# ls
.host .master base config dma intr ioc3 mem mem.be mem.le rom rom.be rom.le tty usrpci
/hw/node/xtalk/9/pci/7/# ls
.host .master base config dma intr ioc3 mem mem.be mem.le rom rom.be rom.le usrpci
