[cz7asm]

Hello, I have a problem with my Fuel that when it boots after some time being left powered down it hangs on "TLB Refill Exception on node 0" as shown in the L2 output below. It happens during SCSI probe. If I reboot the machine then it boots fine and the problem starts again after being left powered down for some time. I got a tip that it could be a bad Dallas time keeping chip (the bulky black chip by the PCI slots) but I cannot see the connection as I'm not really sure about its function. Could this be the problem and if so could someone explain the connection between the chip and this behavior? Any other suggestions are welcome. Thanks.

Installing PROM Device drivers ............         
Base I/O Ethernet set to /dev/ethernet/ef0
Installing Graphics Console...
graphics install: searching for pipe 0

Walking SCSI Adapter 0, (pci id 1)
1timeout on adapter 0 target 1
  tm0=0xffffc4d2b3f2a559, tm1=0xfffed7de6decac02, timeout=0xb
- 2+ Device Vendor Product:
3+ Device Vendor Product:
4+ Device Vendor Product:
5+ Device Vendor Product:
timeout on adapter 0 target 5
  tm0=0xfffed7de6decac07, tm1=0xfffed7de6deca320, timeout=0xb
6+ Device Vendor Product:

A 000: *** TLB Refill Exception on node 0
A 000: *** EPC: 0xc00000001fc47e58 (0xc00000001fc47e58)
A 000: *** Press ENTER to continue.
A 000: POD IOC3 Dex>