[Irinikus]

Again, I'm going to try to model this machine as accurately as possible with the information available on the internet.



This is the info that I've acquired so far:

I really had to scour the internet to get a picture of the CM-2 processor board, which is the basic building block of one of these little animals, this was the only complete picture I could find anywhere!



So I'll start off by modelling it!

Here's a picture of the chassis from the inside: (Take note that this is not a complete system, but it successfully shows how the cabinet fits together)

It's enough information for me to build one!



This image shows some of the systems vents:



This picture gives some idea as to how the processor boards were arranged and how the front panels could slide sideways, allowing access to them:



These images give some insight as to the backplane arrangement: