Reality Engine 1 bus terminator identification
#1
Reality Engine 1 bus terminator identification
In a private message i was helping out a forum member with RM4T/RM5T bus termination on the Reality Engine on Crimson/4D system.

I opened up my Crimson to measure the resistor network pack and to my surprise the values measured do not seem to make much sense. The outermost two pins have 0.5 Ohm resistance and the rest have infinite resistance i.e. they are all open circuit.

So maybe there are diodes inside the pack but my diode checker didn't find anything.

This is a picture of the component:

[Image: RM5TBusTerminator.png]

Can anyone shed som light on this part?
dexter1
Administrator

Trade Count: (1)
Posts: 297
Threads: 17
Joined: May 2018
Location: The Netherlands
Find Reply
11-16-2020, 09:47 AM


Messages In This Thread
Reality Engine 1 bus terminator identification - by dexter1 - 11-16-2020, 09:47 AM
RE: Reality Engine 1 bus terminator identification - by weblacky - 11-16-2020, 06:57 PM
RE: Reality Engine 1 bus terminator identification - by dexter1 - 11-16-2020, 08:56 PM
RE: Reality Engine 1 bus terminator identification - by Irinikus - 11-16-2020, 09:25 PM
RE: Reality Engine 1 bus terminator identification - by weblacky - 11-17-2020, 04:06 AM
RE: Reality Engine 1 bus terminator identification - by SuigintouLain - 11-17-2020, 04:14 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)