[indy99]

I’ve not found any info on manual PROM dumping new stations (only older ones). I was hoping that someone had already done these things. Perhaps the fact they haven’t means the flash region isn’t accessible or are spread over several ICs?

The L1 command "eeprom" outputs a stream of hexadecimal data that might or might not offer what you're looking for.

Documentation I have access to is limited to the l1 command "hlp eeprom"; which returns

Code:

001c01-L1>hlp eeprom
eeprom
           show brick eeprom data

eeprom <exp> <exp> <exp>
           show brick eeprom data at <eeprom> <offset> <length>

eeprom Fuel write default
           write standard Fuel EEPROM sata to MAC EEPROM

An L1 eeprom run on my Tezro returns data in hex format for a number of hardware system, including but not limited to the node, DIMM(s), Odyssey, and Snowball (DM3). None of my SGI systems are connected to the internet, so forgive me for not manually re-entering a couple of hundred lines of code.

In contrast to the IC rich Fuel system board, here's one of a nodeless O350 for contrast: