IRIXNetwork


  1. IRIX Network Forums
  2. SGI/MIPS
  3. IRIX/Software

Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000
#1
Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000
This video shows the procedure of switching between 24-bit and the default colour mode in order to run Quake in software mode on an SGI Indigo2 R4000:

YouTube
Photo Gallery
(This post was last modified: 01-03-2020, 03:21 PM by Irinikus.)
 Irinikus
Hardware Connoisseur

Trade Count: (0)
Posts: 3,475
Threads: 319
Joined: Dec 2017
Location: South Africa
Website Find Reply
01-03-2020, 03:21 PM
« Next Oldest | Next Newest »


Messages In This Thread
Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-03-2020, 03:21 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-03-2020, 05:31 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-03-2020, 06:53 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-03-2020, 08:54 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by dexter1 - 01-07-2020, 07:39 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-07-2020, 07:53 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by dexter1 - 01-07-2020, 08:26 PM
RE: Switching between 24-bit and default colour modes to run Quake on a SGI Indigo2 R4000 - by Irinikus - 01-07-2020, 08:32 PM

Forum Jump:


Users browsing this thread: 1 Guest(s)