indy XZ graphics upgrade: saving irix 6.5.22 install - Printable Version

+- IRIX Network Forums (//forums.irixnet.org)
+-- Forum: SGI/MIPS (//forums.irixnet.org/forum-3.html)
+--- Forum: Beginners' Questions/Tips (//forums.irixnet.org/forum-6.html)
+--- Thread: indy XZ graphics upgrade: saving irix 6.5.22 install (/thread-3825.html)

---

indy XZ graphics upgrade: saving irix 6.5.22 install - ghost180sx - 02-03-2023

I've found the previous forum post on reinstalling graphics eoe components, when upgrading from XL8/XL24 to GR3-XZ board sets. I'm trying to save my current IRIX install as I've spent quite a bit of time setting everything up just the way I like it.

I followed the procedure except for one thing: after copying the files to a temp directory, I dropped into single user mode and serial console to do the install. It completed just fine, rebuild the kernel, and I rebooted. But, on rebooting, it seems Xsgi dosen't even try to launch and I've lost the most important binaries in /usr/gfx like /usr/gfx/setmon, etc.

Is it absolutely necessary to do this procedure booted from a CDROM or over the network in the SASH?
If not, what do I have to do to reinstall the graphics subsystem completely, that is missing in this procedure?

---

RE: indy XZ graphics upgrade: saving irix 6.5.22 install - ghost180sx - 02-05-2023

So, long story short, you MUST do this from SASH or the boot PROM software installer. Don't attempt to upgrade your graphics subsystem in single user mode. When I tried to do that, my system removed all graphics drivers and chagned my system to be server-only mode (headless).

---