SGI Tezro Rack Model won't see V12 - Printable Version
+- IRIX Network Forums (//forums.irixnet.org)
+-- Forum: SGI/MIPS (//forums.irixnet.org/forum-3.html)
+--- Forum: Hardware/Triage/Repair (//forums.irixnet.org/forum-11.html)
+--- Thread: SGI Tezro Rack Model won't see V12 (/thread-1373.html)
+- IRIX Network Forums (//forums.irixnet.org)
+-- Forum: SGI/MIPS (//forums.irixnet.org/forum-3.html)
+--- Forum: Hardware/Triage/Repair (//forums.irixnet.org/forum-11.html)
+--- Thread: SGI Tezro Rack Model won't see V12 (/thread-1373.html)
SGI Tezro Rack Model won't see V12 - billy - 07-19-2019
Please help , i power ON Tezro Rack Model , 4x700Mhz & V12 , log = SSN not recognize , L1> power u = Not able to power ON
log = error "invalid SSN value " so i do this L1>> serial set P1001291 , then Power ON again , Log is FIX SSN, i wonder my DS1742W still a good ??
now my log in below picture 1 , Log = ALLERT: "SNOWBALL EEPROM read error , no acknowledge " & PS 2 EEPROM board info checksum error"
Can any help me to explain what is the failure.
i continue to boot form disk is OK
but system not recognize V12 GFX.
also during POST error " xbow_base: 0x9200000000000000 link: l2 Widget present, but link not alive! " is this for V12 ???
RE: SGI Tezro Rack Model won't see V12 - Raion - 07-19-2019
Thread formatting fixed and moved to correct forum.
RE: SGI Tezro Rack Model won't see V12 - HAL - 07-19-2019
Hmm,
I'd say the snowball error refers to a DM3 that could have been there once and was removed in order to install a V12.
That brick has also been part of a 2-brick setup and complains about the missing brick.
Is the Pxxxxxxx-number you are trying to set the one on the label on the back of the brick ?
I once had a similar problem with my O350s which I eventually fixed with a L3-controller.
RE: SGI Tezro Rack Model won't see V12 - NoodlesMcPastaMan - 07-24-2019
I am having a really similar issue with my v10 and Origin350. Snowball error, no serial number, xtalk error. Mine is down to a bad backplane.
RE: SGI Tezro Rack Model won't see V12 - hamei - 06-28-2020
(07-24-2019, 03:11 PM)NoodlesMcPastaMan Wrote: I am having a really similar issue with my v10 and Origin350. Snowball error, no serial number, xtalk error. Mine is down to a bad backplane.
For future searches, the "snowball error" is not an error. It just means there's no DM card installed.